Machined, heat treated steel safety selector puts oversized levers on both sides of the receiver for easy ambidextrous operation. Large surface area allows you to operate the safety while wearing gloves, and eliminates fumbling in the dark.
Features and Specifications:
Manufacturer Number: XTS-SSL
Machined, heat treated steel
Ambidextrous
Features and Specifications:
Manufacturer Number: XTS-SSL
Machined, heat treated steel
Ambidextrous
5 Ratings
Too wide for a mil-spec ar15 lower.
Functions ok, but it was about 1mm too wide for the receiver. Had to add an o ring to keep it tight to the side.
July 26, 2022
Nice safety,good price.
It's a good price for a good safety. It's not pretty or fancy ,its practical and usable. If you are building a cheap plinker this is the way to go. Installation was as expected and it has a positive click when you use it.
July 13, 2022
This worked but does not have a superior fit
I installed this and it works BUT the fit is a wide, that is to say the detent pin holds it in place and the left side sticks out and is not flush with the receiver.
January 1, 2018
Works fine
IF you are looking for a familiar feel to your safety on the right side being that it is the same size lever on both sides then this is the safety for you. it installed easily and has the same feel as the old factory safety. Pros: easy to locate Cons: Some grips may interfere with smooth operation.
July 6, 2017
Poor quality ,selector do
Poor quality ,selector does not index at correct position Rough surface under selector switch scratched receiver,I spent 1 Hour fitting switch to barrel of selector for proper for.All this for a few bucks saved and it still is unsightly.Next time I will pay a few bucks more and throw this in the trash .
March 6, 2017
Will this fit the S&W M&P 15/22 rifle?
Answer:
No, it will not.
It is too long. Requires washers or shims
Answer:
This is standard size and fits without washers or shims in the AR-15 rifle.