When you rapid fire your SKS it never fails that you end up getting hit by hot shell casings put an end to all of this with this advanced tactical mount that not only allows you to mount an optical device, but is a shell deflector too! One piece, lightweight aluminum design is easy to install and does not require gunsmithing.
Features and Specifications:
Manufacturer Number: SM8570
1 Piece
Shell Deflector
Black
Features and Specifications:
Manufacturer Number: SM8570
1 Piece
Shell Deflector
Black
5 Ratings
Great SKS scope mount!!
Doesnt feel cheap like the dust cover scope mounts out there. Mounting it was easy. To get it as snug as possible I filed a little bit off (underneath the rear sight mount) at a time. Once I filed enough material off I was able to get the provided bolt through where the rear sight mount used to be. Overall appearance looks very modernized with an aftermarket stock
May 12, 2018
Not for a Chinese sks. Trying to find a fix.
I ordered this without reading the comments. I have a norinco Chinese sks. I filed down the front prongs and got a really good tight fit on the bolt receiver. But like all the other complaints. When I started trying to zero it the small bolts that keep the whole platform stable came loose. Had it sighted in at 25 stepped back and tried at 50. Wasn't hitting the target. Looked at the weapon and sure enough the whole platform was wobbling a pretty good amount. So I brought it all back home and I decided to try to put some of the red extra strength thread locker on the bolts. I'm going to let it set and cure for 24 hours then go out and try again. I will keep you updated. However if this doesn't work. My other plan is that since this mount is solid metal I might just weld it to the receiver block it came with in a few different places. Just trying to turn my sks into a good pig gun. I only need to be able to put a shot grouping in the size of a can at about 70 yards. Not looking for pin point accuracy. Plan on keeping you updated to see how well it works out.
March 16, 2018
Do not buy if you have a
Do not buy if you have a Chinese SKS. Would not initially fit. Had to file away aluminum from multiple surfaces to make fit. After doing so I thought I had a solid mount for a red dot. Went to rang to sight it in. After ten shots i still could not get it to zero. I then noticed some play of about a 1/16' in rail. Immediately unloaded gun and went home to disassemble. The back pin hole had split open. Again do not buy for Chinese model. May work for others but it is quite a risk for the price.
June 3, 2016
As stated in the previous
As stated in the previous review,mine also took some modding to get it to fit my yugo,and I to burred the front post where it connects to the site base.....a redo would be great,as I didn't even leave a review for months I was so bothered by the burring...a little sand paper and the right finish I think it will be alright, how ever its a great product, just need a youtube video or something showing installation
April 11, 2016
Very nice product, howeve
Very nice product, however I needed to mod it a little to fit my yugo. Ended up bending and burring the front post a little, idk if I had another I could do it properly now. No info on the Web on install anywhere. That being said installed and looks good, just wish it came with instructions. Over all would love a redo now that I know what I'm doing, until project money's get freed up I will be content with my slightly burred unit, as much as that screams to my mind.
February 8, 2016
Does the frount of this mount go were the rear sight goes?
Answer:
Yes
Does it replace spring cover or just mount over cover
Answer:
This replaces the factory dust cover.