Polymer 80, otherwise know as P80 has come up with a replacement slide for specific GLOCK pistols. The replacement slide allows you the opportunity to completely customize each and every part you choose to install onto the slide. Everything from the barrel, the recoil spring assembly, sights and even the internal slide parts must be purchased separately and installed by you. The slide is made from 17-4 Stainless Steel and is heat treated to 42-43 HRC. Then the slide is treated with a evenly applied Physical Vapor Deposition, or PVD coating for the ultimate in durability, lubricity, and wear resistance. If you have always wanted to try the ultimate DIY gun project then pick up one of these P80 GLOCK slides today!
Specifications and Features:
Polymer 80 GLOCK 19 Gen3 Compatible Slide P80PS9CSTDDL
Aggressive Front/Rear Serrations
17-4 Stainless Steel Construction
Heat Treated to 42-43 HRC
Physical Vapor Deposition Coating (PVD)
Made in the USA
Matte Black Finish
Slide Internal Parts
Recoil Spring Assembly
Note: Assembly by a competent gunsmith or GLOCK Certified Armorer is highly recommended.
DISCLAIMER: “GLOCK” is a federally registered trademark of GLOCK, Inc. and is one of many trademarks owned by GLOCK, Inc. and GLOCK Ges.m.b.H. Neither Cheaper Than Dirt!, nor this site are affiliated in any manner with, or otherwise endorsed by, GLOCK, Inc. or GLOCK Ges.m.b.H. The use of “GLOCK” on this page is merely to advertise the sale of GLOCK pistols, parts, or components. Components and parts that do not specifically have GLOCK listed as the manufacturer are made by their respective company. Such parts may be intended for use with GLOCK components but are not produced by GLOCK, Inc.. For additional genuine GLOCK, Inc. and GLOCK Ges.m.b.H products and parts visit www.glock.com.