Upgrade your rifle with the Patriot Ordnance Factory 7 Position Buffer Tube. POF's Mil-Spec 7075-T6 aircraft aluminum Anti-tilt Buffer Tube uses "carrier cradle" extensions to ensure that the carrier is always supported by the buffer tube, even when the bolt is forward. This prevents carrier-tilt and premature wear on the buffer tube. Thusly, the buffer detent button doubles as a lock that stops the buffer tube from rotating and becoming loose under extreme operation conditions. POF's designs also features three extra drain holes for marine environments.
Note:
ONLY COMPATIBLE with P308 rifles manufactured in October 2012 or later. If your rifle was manufacture BEFORE October 2012, you will need the 6 position buffer tube.
Note:
ONLY COMPATIBLE with P308 rifles manufactured in October 2012 or later. If your rifle was manufacture BEFORE October 2012, you will need the 6 position buffer tube.
2 Ratings
Fits my BCM GunFighter st
Fits my BCM GunFighter stock snugly, however it does have a chamfer running down the side of the tube's key, which is causing some interference but nothing too significant. Though it has some white marks, this just seems to be packing residue of some kind and is easily wiped off; finish is as it should be otherwise.
October 20, 2016
FYI, the note in the desc
FYI, the note in the description that says Note: ONLY COMPATIBLE with P308 rifles manufactured in October 2012 or later. If your rifle was manufacture BEFORE October 2012, you will need the 6 position buffer tube. refers to POF rifles only. I Just talked to them. This tube should fit any Mil Spec AR15 or AR10 you build - but call them yourself to be sure if in doubt.
May 3, 2016
how long is it. you would think this would be called out?????????
Answer:
That is a standard specification and like the inner diameter and thread pitch are not usually spelled-out in the description. This is Right about 8 inches long.