The REACT Torch and Vertical grip by Mission First Tactical combines a tactical flashlight mount and a rail-mount vertical grip into one unit. The mount will accept lights from 5/8" to 1" in diameter. The light is activated by a switch on the rear of the grip. There is also a provision for a pressure pad on the right side of the vertical grip that can also be used to activate light. A lock-out switch prevents the light from being activated unintentionally. The grip features a secure, water-tight storage compartment. Constructed of durrable polymer.
Features and Specifications:
Manufacturer Number:RTG
Black
Combination vertical grip and illumination mount
Accepts light sources of .825" - 1" diameter
Lock-out switch prevents unintentional activation of light source
Grooved gripping surfaces to eliminate hand slippage
Pressure pad wells allow light activation for RH Operators
Thumb activation switch for wireless light activation
Secure watertight storage compartment
Customizable foam storage block with quick access tab diminishes rattle
Flat non-slip bottom surface aids in supported firing positions
Fits Picatinny
Weight: 7.4oz
Height: 4.727"
Width: 1.573"
Length: 4.833"
Features and Specifications:
Manufacturer Number:RTG
Black
Combination vertical grip and illumination mount
Accepts light sources of .825" - 1" diameter
Lock-out switch prevents unintentional activation of light source
Grooved gripping surfaces to eliminate hand slippage
Pressure pad wells allow light activation for RH Operators
Thumb activation switch for wireless light activation
Secure watertight storage compartment
Customizable foam storage block with quick access tab diminishes rattle
Flat non-slip bottom surface aids in supported firing positions
Fits Picatinny
Weight: 7.4oz
Height: 4.727"
Width: 1.573"
Length: 4.833"
I like this grip. It work
I like this grip. It works great if you put about 3 minutes of prep work into it. I decided to drill the safety button out, because who needs a safety for a light? Also, when you drill the safety button out, it allows you to push the thumb activation switch in further, which is good for lights with thumb push button activation. With the safety switch in, I could momentarily switch my light on, but the button would not go far enough in to turn (full on) my Streamlight Polytac LED tactical light. With the safety drilled out, it works perfectly, and can get momentary activation to blind and disorientate, or full on. Would have given it 5 bullets if I didn't have to drill out safety. Also comes with two different adapters for different sized lights.
September 10, 2012
Does this fit the Jts mak 12 gauge ?
Answer:
You would need to add a picatinny rail to the handguard to mount this and the M12AK has proprietary furniture.