The Fobus Standard Holster sets the standard for concealed carry. State-of-the-art design, injection molding and high density polymer have created a holster that cannot be duplicated in leather or any other material. The Standard Series is a passive retention holster that secures the firearm from becoming dislodged during moments of high activity. Drawing and holstering are both smooth and efficient.
Features and Specifications:
Manufacturer Number: TA85
Lightweight 2oz. holster
Low profile design for concealability
Passive retention allowing rapid presentation
Rubberized paddle insert for extra stability
Reinforced rivet attachment
Right hand
Material: Polymer
Finish: Black
Fits:
Rossi 35102, 35202, R351, R352
Taurus 605 (no polymer frame), 650, 651, 85 (no polymer frame), 850 CIA, 905, UL85 (no polymer frame)
Features and Specifications:
Manufacturer Number: TA85
Lightweight 2oz. holster
Low profile design for concealability
Passive retention allowing rapid presentation
Rubberized paddle insert for extra stability
Reinforced rivet attachment
Right hand
Material: Polymer
Finish: Black
Fits:
Rossi 35102, 35202, R351, R352
Taurus 605 (no polymer frame), 650, 651, 85 (no polymer frame), 850 CIA, 905, UL85 (no polymer frame)
This is an all-around ver
This is an all-around very nice accessory. It is very sturdy and well built. Adds ease of access and quick attachment if you're in a hurry. It did not earn 5 bullets from me because it's a little too low hung for effective concealment.Otherwise I am compleatly satisfied with this holster and would would highly recomend it to anyone.
November 9, 2008
Will my Charter arms 44spl fit?
Answer:
No this holster will likely be too small.
Will this fit the Taurus 605 Defender with the 3 inch barrel?
Answer:
This holster was designed for the 2" models. The bottom of the holster is open and this will fit, however, your barrel will extend an inch past the end of the holster.
Will this fit a S&W .38 air weight bodyguard w/built in laser site?
Answer:
Depending on where the laser is. If it is a grip laser it should work just fine.