Faxon M&P 2.0 Compact Flame Fluted Barrel, Non-Threaded
Features and Specifications:
Manufacturer Number: M&PB910NC2LOQ-N
Caliber: 9mm
Profile: Flame Fluted, Drop In
Material: 416-R Stainless Steel
Twist: 1:10
Thread: None
Crown: 11º Target Crown
Rifling Method: Button
Rifling Type: Conventional
Inside Finish: Salt Bath Nitride
Outside Finish: Salt Bath Nitride
Fits:
M&P 2.0 Compact
Note: This product is new and being closed out; sold "As Is" and is not returnable to Cheaper Than Dirt. Please contact the manufacturer for warranty and assistance.
Features and Specifications:
Manufacturer Number: M&PB910NC2LOQ-N
Caliber: 9mm
Profile: Flame Fluted, Drop In
Material: 416-R Stainless Steel
Twist: 1:10
Thread: None
Crown: 11º Target Crown
Rifling Method: Button
Rifling Type: Conventional
Inside Finish: Salt Bath Nitride
Outside Finish: Salt Bath Nitride
Fits:
M&P 2.0 Compact
Note: This product is new and being closed out; sold "As Is" and is not returnable to Cheaper Than Dirt. Please contact the manufacturer for warranty and assistance.
1 Rating
Don't buy it
I purchased this barrel a while ago and never had to time to take it out a test it due to work schedule. I only run factory mags in my guns except for my Sig Sauer 226 in which I run Mec-Gar, so the magazine is definitely not the issue here. I noticed while chambering the first round it had a bit of drag to it before the round actually seated in the chamber. I fired 1 round and the second stopped dead in its tracks about half way up the feed ramp. Cleared the malfunction and fired the second round. Worked fine. 3rd round same issue this repeatedly happen for the remainder of the magazine. I popped in the factory barrel and ran the same magazine without a hiccup. I then put the replacement barrel back in and same thing over and over again. I could probably polish it up and it would work fine but I'd never really trust it. Lesson learned. No flaw to CTD. Don't buy it guys and gals.
April 28, 2021
I have an mp 2.0 subcompact 3.6" , this should drop right in and just be slightly longer than the rest of the pistol/the barrel will stick out further than the slide, correct?
Answer:
Yes, this will fit your firearm.
Larry again, I have a M&P 2.0 Compact .40 will this barrel work in mine to convert it to 9mm, with the 9mm magazine? I forgot to state that I have a 2.0 in first question asked!
Answer:
No it will not work as a conversion barrel.
Can this 4", 9mm 2.0 Compact barrel, be used in my M&P .40 Compact with a 4" barrel? To convert it to 9mm, I do have the 9mm magazines!
Answer:
Not as far as I know.
Is this a 4" replacement barrel?
Answer:
Yes
What is the barrel length I'm looking for a 4"
Answer:
This fits the M&P 2.0 Compact, which has a 4" barrel.
Can this be used as a .40 to 9mm conversion barrel or is it only direct replacement for 9mm compact?
Answer:
This is a replacement barrel.