Deltac is the tactical accessories division of Funding USA LLC a small, family owned American business located in Texas.
They offer a variety of products to the sports shooting and hunting community.
Since inception, DELTAC has been determined and focused to bring its customers the best quality products available while offering some of the most competitive pricing in the marketplace
Deltac believes that threading the barrel of the Mosin Nagant is the most effective method to install a muzzle brake on your Mosin Nagant because their barrel are not always concentric. There are many breaks on the market that just mount with a bracket secured behind the front sight that end up being shot off with an exiting bullet and are potentially dangerous. Threading your barrel with the use of the enclosed threading tool insure your thread are true and are permanent but ensure reliability and accuracy.
Note: Suggest this to be done by a gunsmith.
Features and Specifications:
Manufacturer Number: PKG113
Type: Muzzle Brake
Length: 2.520 inches
Exit hole .340 inches
Thread: M15x1 RH (Right hand threads)
Machined from top quality steel and finished in black oxide.
Round adjustable die in M15X1RH (Right hand threads)
Thread alignment tool:
This is a simple TAT (thread alignment tool) for re-threading 7.62 caliber muzzles to accept the above M15 X 1 RH muzzle device.
The extended 3" long stem helps with *Mosin-Nagant barrels which have been counter-bored to renew the muzzle crown..
It helps you get the die started level and on-center to prevent costly mistakes.
Material: US made 303 Stainless Steel
#5 Die Handle
This a heavy duty #5 die handle is approx. 11.5in long and accepts 1.5in dia (38mm) dies like the M15X1 RH die that we offer on this site. The handle ends are not removable. These are high quality handles made of high tensile steel.
* The Russian arsenal sometimes counter-bore the barrels to prolong their life by cutting out the bad/worn rifling at the muzzle end. If done properly a counter-bore has the potential to improve accuracy. The length of the counter-bore depended on how worn the muzzle end was. You should measure the depth of the counter-bore to make sure that this tool is long enough to reach the caliber bore of the rifle.
One Threaded muzzle brake
One M15X1 RH Die
One Thread alignment tool with a 3" long stem
#5 die handle
One Jam nut