Winchester 1300 12 Gauge Pump Shotgun Scope Mount Satin Black
Features and Specifications:
Manufacturer Number: ASM-8
Fits Winchester 1300 12 gauge pump shotguns
Saddle-style mount
Slides down receiver and straddles both sides
No gunsmithing required
Quick target acquisition
Standard dovetail mounting rail
Accommodates Weaver/Picatinny rings & electronic sights
MIL-SPEC Type II anodized
Installs quickly
Non-glare satin black
Note: This product is not returnable to Cheaper Than Dirt. Please the manufacturer for warranty and assistance
Features and Specifications:
Manufacturer Number: ASM-8
Fits Winchester 1300 12 gauge pump shotguns
Saddle-style mount
Slides down receiver and straddles both sides
No gunsmithing required
Quick target acquisition
Standard dovetail mounting rail
Accommodates Weaver/Picatinny rings & electronic sights
MIL-SPEC Type II anodized
Installs quickly
Non-glare satin black
Note: This product is not returnable to Cheaper Than Dirt. Please the manufacturer for warranty and assistance
Aimtech Saddle on Winchester 1300
Fit my Winchester 1300 perfectly. Very easy to install, 5 minutes tops. Seems to be solid. Did use blue locktite on threads and only snugged up screws. Do not over tighten them. Read other reviews that did tighten up too much at first and couldn’t work the action properly. Could only give 4 ⭐️’s because have not tried it out at the range yet to see just how solid it is. Don’t believe it will let me down.
August 3, 2024
Perfect fit
Fit my Winchester 1300 with no problems. Definitely a 3 minute install. Did use a little blue loctite on the screw because I did not over tight them.
July 27, 2024
I had no difficulty insta
I had no difficulty installing this product on my Defender (and no trouble with the supplied trigger pin replacement). However the chin strap design falls a little short. The chinstrap is secured with small Allen screws on either side that screw into the rail mount and not the gun. There is a nylon tipped set screw that goes into the center of the chinstrap and secures the front of the assembly against the trigger assembly. The problem is that I found that the set screw can't be tightened more than slightly, or it exerts pressure on the trigger assembly which in turn binds the action making it hard to pump. So I backed off the set screw and the slide action is now fine, but because the set screw on the chin strap is not very tight there is some slight up and down give to the installed rail. this is not a big deal as we are talking shotgun here and not precision long range shooting, but I worry that the little bit of give will encourage the screws to loosen up over time. I used loc-tite as recommended so we will see.
January 3, 2010
Well, out of the box it l
Well, out of the box it looks great. Inspection looks nice and sleek. Like they stated easy install.Until I tried to replace the trigger group screw. I'm assuming it the head is supposed to sit flush with the mount. That is fitsinto the 'countersink'. There is a ridge at the bottom of the cswhere the head should rest. Well either the screwhead is too bigor the countersink diam is too small. I plan to drill the cs or grind the head. Easy but not quite as easy as I had expected.
September 18, 2008
Is this made out of plastic?
Answer:
No it is not.
Does this fit the 20 gauge model 1300?
Answer:
No this will not fit.
This will work on a Winchester Defender Model 1300 correct ?
Answer:
Yes this will fit.
I heard this could fit a stevens 320?
Answer:
No it will not.