Fits most single-barrel 12 gauge shotguns
(.850-.900" diameter)
(.850-.900" diameter)
it fits
I have used these for years on various arms. the older style was higher quality it seems, with the tightening screw with the swivel hole through the middle was lower profile and easier to install, also the "steel" of the tightening screw is so soft, even with my weak arthritic hands, stripped out the allen head, be wary!
September 26, 2022
it fits
I have used these for years on various arms. the older style was higher quality it seems, with the tightening screw with the swivel hole through the middle was lower profile and easier to install, also the "steel" of the tightening screw is so soft, even with my weak arthritic hands, stripped out the allen head, be wary!
September 26, 2022
I have a Stevens 620 tren
I have a Stevens 620 trench gun that would normally take a handguard with a built in sling swivel. These are hard to find and expensive when you do find them. I was looking for a full barrel band, also hard to find in the right diameter. So, the Uncle Mikes setup seems to be the way to go. The set screws are very small and it took a little work to put this setup on my gun. However, the fit seems good and once tightened down seems solid. Be patient when adjusting the fit.
February 19, 2014