New customer? Click here to login or create an account.  Click to Sign In
Category:
Leapers UTG SKS Scope Mount Integral Ring Cover with Rings and See Thru
Click here to view a larger image
Leapers UTG SKS Scope Mount Integral Ring Cover with Rings and See Thru
ImportantPlease Note
We're sorry, but this product is no longer available.

Please click here to be notified by email if this product becomes available.
Manufacturer: Leapers UTG MNT-640T5
Item: SCP-250
UPC: 4715643226019

SKS receiver cover mount with 1" scope rings which are integral to the receiver. Just replace your factory rear receiver cover install scope and you are ready to sight in. Will work for either Chinese or Russian Rifles. May require minor filing on front of mount for a snug fit, complete with instructions on how to adjust for a perfect, solid fit. The scope rings are one inch, so this mount will not work with 30mm or rubber armored scopes like our SCP-026. Manufactured by Leapers.
Average Customer Rating: 3.9 Rating (48 Customer Reviews)  Write a Review!
Page 1 of 10 (48 Reviews)
‹ 1 2 3 4 5  ... ›  Show All Sort:
5.0 Rating Not Bad - 12/27/2010Leapers UTG SKS Scope Mount Integral Ring Cover with Rings and See Thru5.0000
Reviewer: Huey
After all the reviews, I figured this would be a nightmare, but got it anyway. Yes, it did take a little filing, and I broke one of the set screws tightening it, but overall this product works well for the price. Once I got it on and put some locktight, its solid as a rock. As long as you don't mind putting a little bit of effort into it, its definitely worth the price. PS. I have no previous gunsmithing experience and got it no problem.
1.0 Rating no good - 12/19/2010Leapers UTG SKS Scope Mount Integral Ring Cover with Rings and See Thru1.0000
Reviewer: chris
Very poor replacement part, I had a very difficult time getting the cover to fit and when I finally did, the action of the bolt was bound up. It would not pull back at all! The rails inside of the new cover were too thick and would not fit inside of the groves on the original bolt! Therefore I took the rings off and trashed the cover. Would not recommend at all!
2.0 Rating Looks good - 11/5/2010Leapers UTG SKS Scope Mount Integral Ring Cover with Rings and See Thru2.0000
Reviewer: CaliforniaCPL
It looked good out of the box. It required a lot of filing before "fitting" onto my Russian SKS. Major down fall is my bolt rubs against the inside of this mount. I havn't actually fired it with this system mounted, but the rubbing is bad enough where I can imagine it may hinder cycling. Even if it doesn't cause a malfunction, I'm not going to use this mount knowing it is going to add extra wear and tear (and/or damage) to my Russian SKS.
3.0 Rating Discrepancies - 10/25/2010Leapers UTG SKS Scope Mount Integral Ring Cover with Rings and See Thru3.0000
Reviewer: AlS.
I purchased this mount for SKS rifle. I read all the crap about it on CTD. I inspected it and found that most complaints were valid. Further investigation found that threads tapped into the mount (receiver cover) are not metric, however supplied with metric screws, very loose, and don't think Locktite would secure them satisfactorily. The threads tapped into the mount for the four locking screws are 10-32USS, not metric. 10-32USS setscrews with cone point and 3/8" long work fine and actually fit the threads tapped. The threads for the scope mount are 8-32 USS, and sockethead screws fit nicely and tight. 3/8 inch work fine, may have to shorten with grinder so don't interfere with bolt. I found this problem with the SKS rifle. You would think it would be metric, but Chinese are using USS threads on lots of stuff produced there. The cone shaped allen head screws will secure it very well, and it will never move. As long as they are 10-32 thread, and the bracket screws are 8-32. Loctite probably not needed.
4.0 Rating Not the best - 10/17/2010Leapers UTG SKS Scope Mount Integral Ring Cover with Rings and See Thru4.0000
Reviewer: Robert1911
While this is not the best scope mount out there for the SKS, the pic rail one is far better, it does the job. Be ready to have to file down the front teeth and make sure to check how tight the mount screws are every time you get ready to use the rifle, they will come loose even with loc-tite.
 
Our Guarantee | Return Policy | Change Account Information | Privacy Policy | Government Sales | Forums
Product Map | Order a Catalog | Join Our E-Mail List | Shipping Information | Gift Cards | Hot New Items | Closeouts | Retail Store
Ask A Question | How to Order | Track Order | Mail Order Form | Firearm Order Form | FAQs | Terms of Use
© 2013 Copyright, entire contents by CTD, Inc.
Cheaper Than Dirt! is a registered trademark of Direct Investments, Ltd. All Rights Reserved

This website is best viewed with Internet Explorer 8.0 and FireFox 15.0 with a screen resolution of 1024 x 768 or higher.
Leapers UTG SKS Scope Mount Integral Ring Cover with Rings and See Thru
Leapers UTG SKS Scope Mount Integral Ring Cover with Rings and See Thru		x