I bought this for my Mossberg 500. It only took about 2 minutes to take off my orginal stock and put this on. It fit perfectly and looks great on my shotgun. If you have a shotgun for home defense you have to get this. It makes the gun much shorter so it is easier to maneuver through doors and hallways. If you live in communist kalifornia like me get it before they ban it. Highly recommended.

I bought it for my Sears Model 200- or as everyone on the internet says, the Winchester 1200. It didnt fit, even with all the attachments. It is not meant for it, plain and simple.

This is a very attractive pistol grip made from high quality plastic. It fit my Norinco 98 series shotgun which is nearly identical to the Remington 870. It was easy to install and looks great. Get this pistol grip.

This pistol grip is superb! It fits my Mossberg 500 like a glove, it comes with adaptors for an Rem 870 a Winchester I think, but no adaptor is needed for the Mossberg, which shows that this is what it really was designed for! It took under 2 1/2 mintues to install, what took my longest was finding a long flathead screw driver. Only two small complaints; it didnt come with the cap at the end of the grip to cover up the bolt (packaging say it should have), but its barely noticeable. The other complaint is that in order to disassemble your gun, you need to take this grip off to get the trigger group out. It only takes 1 mintue to do. Both of these problems are so small I didnt take points off! This grip is nice and solid, doesnt feel "cheap" at all. Trust me, if your looking for a nice pistol grip for your Mossberg, GET THIS!

This grip took me just under a minute to install including looking for the one tool I needed and removal of the old grip. Fits my M500A like it came from a Mossberg factory. Fits my hand 10x better than the rear grip it replaced (big mitts). If only Specter Gear was as fast as CTD, I'd have my HST sling for it by now too!