In total agreement with the prior two posts. Still trying to break the locked threads. May have to resort to drilling them out and replacing the screw/nut combo. Well molded but the assembly leaves alot to be desired.

Agreed with other poster. Can't adjust tension on mag pouch because of thread-lok on bushing. Had to use small needle-node pliers and put force on threads to adjust. Now is tight enough mag's won't fall out when upside down, but easy to pull still. Not messing with my adjustment screw anymore. What a PAIN.

Too wide out of the box for standard factory Colt 45 single stack mags. Required adjustment via tightening the tension adjustment screw. However, the flange nut and tension adjustment screw turned together, preventing any adjustment - looser or tighter. This was probably due to blue thread-lok applied to the adjustment screw by the Filipino assemblers. In addition, the plastic bushing inside the pouch around the adjustment screw prevented tightening. I broke the thread-lok using needle nose pliers and elbow grease. I removed the plastic bushing and trimmed it shorter with a sharp knife. I was able to tighten the adjustment screw adequately to hold two loaded mags firmly, after these field expedient mods. This design needs work.